FORD PERFORMANCE MODULE JET Power Tech Module Installation Instructions

Download ECU Location Chart #1= Behind the passenger kick panel. #2= Under hood on drivers side #3= Driver’s side kick panel, behind emergency brake #4= Under hood, near top of firewall, near passenger side #5= Passenger side above kick panel #6= Under dash on drivers side, inside plastic sleeve #7= Back firewall, under cowl panel #8= Behind panel below steering column #9= Eng, compartment-pass side rear-under cowl panel #10= Drivers side engine compartment near firewall #11= Above passenger side kick panel #12= Underneath the battery tray, remove battery tray to gain access to PCM connectors #13=Under hood next to master cylinder. YEAR MODEL LOCATION 87 – 94 Bronco II, Explorer #1 89 – 03 Cougar, T-Bird #1 94 – 04 Crown Victoria #8 05 – 07 Crown Victoria #10 93 – 98 E Series Van #6 00 – 05 Excursion All #2 95 – 02 Explorer #4 03 & up Explorer, Sport Track see page 9 87 – 96 F150, 250, 350, Bronco #3 04 & up F150, 250, 350 see page 11 97 – 03 F150, Expedition #5 97 – 03 F250, 350 #6 94 – 97 F250 – 350 Diesel #3 98 – 03 F250 – 350 Diesel #6 06 & up Focus #11 06 – 07 Freestyle, Five Hundred #9 03 Marauder 4.6L #13 06 & up Milan, MKZ, Zephyr, Fusion #12 87 – 04 Mustang #1 04 & up Mustang see page 14 87 – 92 Ranger #1 93 – 95 Ranger #2 96 & up Ranger #4 89 – 04 Taurus #7. Remove negative battery cable. 3. Remove any covers (kick panels, etc.). 4. Remove the ECU mounting bracket screw and pull the ECU out of it’s bracket. 5. On the rear of the ECU remove the warranty sticker or plastic cap to expose the connector. IMPORTANT: It is necessary to clean the protective coating off of the circuit board connection on the factory computer. Using the supplied cleaning pad, gently rub back and forth over the circuit board to remove all of the coating (see pictures). You MUST clean both sides of the circuit board for the module to get a proper contact. Remove any flakes of coating left from cleaning. If the vehicle does not start or any warning lamps stay on after installing the module, reclean the circuit board and remove any residual coating from inside the connec tor on the JET module. 6. Plug the JET Module onto the exposed connector (see pages 4-7 for pictured instructions.) IMPORTANT: When installing the module onto the connector, care should be taken NOT to FORCE the module inside the computer. Damage to your computer could result. 7. To prevent the module from working loose – use the provided mounting strip and tape over the module to hold it on the ECU. 8. Reinstall the ECU, bracket and any panels back in their original location. 9. Reconnect the negative battery cable. 10. Start the vehicle – verify that the service engine light is NOT on and that the idle RPM is normal. If NOT , turn OFF the engine. Verify all the installation proceedures.